The design of tunnel linings requires the solution of a soil–structure interaction problem, simulating both excavation and construction phases. Nevertheless, the preliminary design is performed by using the convergence-confinement method, based on the equilibrium of radial stresses and compatibility at the lining–soil interface. As is well known, this approach relies on the definition of the so-called tunnel characteristic curve, putting in relation mean cavity stress and convergence. The characteristic curve is often derived from analytical solutions, typically assuming (i) infinite ground domains, (ii) infinitely long tunnel with circular cross section, (iii) absence of gravity and (iv) pre-excavation isotropic stress state. This approach allows only to assess the average axial forces on the lining, but not to predict bending moments generated by the tunnel distortion, associated with a non uniform and non isotropic initial state of stress. In this paper finite element numerical analyses results concerning deep tunnels, considering plane strains and undrained conditions, are discussed to demonstrate that (i) the choice of the constitutive model significantly affects the system response and (ii) the anisotropy of the initial stress state leads to non-homothetic deformations.
Finite Element Analyses of undrained cavity unloading considering in-situ anisotropic state of stress
M. Zerbi;L. Flessati;C. di Prisco
2025-01-01
Abstract
The design of tunnel linings requires the solution of a soil–structure interaction problem, simulating both excavation and construction phases. Nevertheless, the preliminary design is performed by using the convergence-confinement method, based on the equilibrium of radial stresses and compatibility at the lining–soil interface. As is well known, this approach relies on the definition of the so-called tunnel characteristic curve, putting in relation mean cavity stress and convergence. The characteristic curve is often derived from analytical solutions, typically assuming (i) infinite ground domains, (ii) infinitely long tunnel with circular cross section, (iii) absence of gravity and (iv) pre-excavation isotropic stress state. This approach allows only to assess the average axial forces on the lining, but not to predict bending moments generated by the tunnel distortion, associated with a non uniform and non isotropic initial state of stress. In this paper finite element numerical analyses results concerning deep tunnels, considering plane strains and undrained conditions, are discussed to demonstrate that (i) the choice of the constitutive model significantly affects the system response and (ii) the anisotropy of the initial stress state leads to non-homothetic deformations.| File | Dimensione | Formato | |
|---|---|---|---|
|
Articolo_SIG_rev2.docx
accesso aperto
:
Post-Print (DRAFT o Author’s Accepted Manuscript-AAM)
Dimensione
812.73 kB
Formato
Microsoft Word XML
|
812.73 kB | Microsoft Word XML | Visualizza/Apri |
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.



