Fracture toughness of AlSi10Mg alloy produced by LPBF: effects of orientation and heat treatment

In this study, AlSi10Mg samples were manufactured by laser-powder bed fusion process to explore the fracture toughness dependence on both built orientation and aging treatment. The experiments were performed on as-built and directly-aged (200 degrees \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document}$$<^>{\circ }$$\end{document} C/4 h) conditions, with the latter revealed to be a valuable treatment for improving fracture toughness. A comprehensive investigation involving detailed microstructural analysis, grain-orientation mapping, and crack-tip strain measurements was conducted to investigate the mechanisms governing the material behavior. The results revealed that specimens subjected to direct aging display higher toughness, thereby enhancing the fracture resistance of AlSi10Mg. Moreover, a considerable variation in fracture toughness values was observed for the different printing orientations, indicating the existence of manufacturing-induced anisotropy. The findings highlight that this anisotropy mainly correlates with the distinctive microstructure induced by the additive manufacturing process. In particular, this study focuses on the different preferential crack paths dictated by the melt pool boundaries orientation respective the crack propagation direction. A substantial reduction in fracture toughness was observed when the crack propagates along the melt pool boundaries.