Effect of suspended solids on peracetic acid decay and bacterial inactivation kinetics: Experimental assessment and definition of predictive models

The work addresses the effect of total suspended solids (TSS) on disinfection by peracetic acid (PAA) concerning both PAA decay and bacterial inactivation kinetics. The effect of TSS on PAA decay was evaluated at five TSS concentrations (5, 40, 80, 120 and 160 mg/L), obtained from stock TSS solutions prepared from activated sludge samples. The influence of the soluble matter associated to the suspended solids on PAA decay was evaluated separately, using the same stock TSS solution after the removal of solids by filtration. The contributions of suspended and soluble fractions were found to be independent, and a predictive model formed by two additive sub-models was proposed to describe the overall PAA decay kinetics. Moreover, an uncertainty analysis was performed by a series of Monte Carlo simulations to propagate the uncertainties associated to the coefficients of the model. Then, the disinfectant dose (mg/L min) was highlighted as the main parameter determining disinfection efficiency on a pure culture of E. coli and an inactivation kinetic model was developed based on the response of E. coli to various PAA doses. Finally, the effect of TSS (40 and 160 mg/L) on the inactivation of free-swimming E. coli was investigated at two PAA doses (5 and 20 mg/L min). TSS reduced inactivation extent an average of 0.4 logs at 5 mg/L min and 1.5 logs at 20 mg/L min. It was hypothesized that this might be due to the formation of bacteria aggregates as defense mechanism against disinfection, enhanced by the presence of solids.