Sfoglia per Autore
Development of a tool for predicting oxides scales and tensile properties of Stelmor-cooled wire rod
2024-01-01 Rivolta, B.; Gerosa, R.; Panzeri, D.; Angelini, L.; Sala, C.; Galluzzi, C.; Cavenaghi, D.; Passoni, R.; Parimbelli, A.
Optimization of the mechanical and corrosion resistance of Alloy 625 through aging treatments
2024-01-01 Rivolta, Barbara; Gerosa, Riccardo; Panzeri, Davide; Nazim, Arsalan
High- and low-cycle-fatigue properties of additively manufactured Inconel 625
2024-01-01 Concli, Franco; Gerosa, Riccardo; Panzeri, Davide; Fraccaroli, Lorenzo
Influenza dell’invecchiamento sulla deformabilità di vergella laminata a caldo
2023-01-01 Rivolta, B.; Gerosa, R.; Panzeri, D.; Piazza, L.; Angelini, L.; Bersani, M.; Bolognani, N.; Panzeri, A.; Parimbelli, A.; Sala, C.
Selective laser melted 316L stainless steel: Influence of surface and inner defects on fatigue behavior
2023-01-01 Rivolta, Barbara; Gerosa, Riccardo; Panzeri, Davide
Deep cryogenic treatment of AA7050: tensile response and corrosion susceptibility
2023-01-01 Gerosa, R.; Panzeri, D.; Rivolta, B.; Casaroli, A.
Influence of annealing in deposited Ti-Pt thin films sensing elements for quartz crystals microbalances
2023-01-01 Vaz Junior, E. V.; Martina, C.; Saggin, B.; Gerosa, R.; Zampetti, E.; Mancuso, M. A.; Longobardo, A.; Palomba, E.; Dirri, F.; Gisellu, C.; Scaccabarozzi, D.
The spinodal decomposition of ferrite in 2507 biphasic stainless steels: embrittlement and possible toughness recovery
2023-01-01 Rivolta, Barbara; Gerosa, Riccardo; Panzeri, Davide; Mariani, Enrico; Tavasci, Francesca
Metallurgical Failure Analysis of Closed Water Circuit Containing Molybdate-Based Inhibitor
2023-01-01 Casaroli, Andrea; Boniardi, Marco Virginio; Rivolta, Barbara; Gerosa, Riccardo; Iacoviello, Francesco
High and low cycle fatigue properties of selective laser melted AISI 316L and AlSi10Mg
2023-01-01 Concli, Franco; Gerosa, Riccardo; Panzeri, Davide; Fraccaroli, Lorenzo
Ottimizzazione termo-metallurgica della lega di nickel 625
2022-01-01 Rivolta, B.; Gerosa, R.; Panzeri, D.; Pizetta Zordão, L. H.
Study of the influence of heat treatment on the metallurgical characteristics of the IN625 alloy
2022-01-01 Pizetta Zordão, L.; Panzeri, D.; Gerosa, R.; Rivolta, B.
Reverse aging of pearlitic carbon steel wire rod
2022-01-01 Rivolta, Barbara; Gerosa, Riccardo; Panzeri, Davide; Piazza, Lorenzo; Angelini, Lorenzo; Bolognani, Nicola; Panzeri, Attilio; Parimbelli, Andrea; Sala, Carlo
Spheroidizing annealing of thermomechanically hot-rolled steel rods: influence of the prior microstructure on the mechanical characteristic and phase transformations
2022-01-01 Rivolta, B.; Gerosa, R.; Panzeri, D.; Piazza, L.; Angelini, L.; Alfonso, M.; Bolognani, N.; Panzeri, A.; Parimbelli, A.; Sala, C.
On the peak strength of 7050 aluminum alloy: mechanical and corrosion resistance
2022-01-01 Gerosa, Riccardo; Rivolta, Barbara; Boniardi, MARCO VIRGINIO; Casaroli, Andrea
TOUGHNESS RECOVERY OF F55 GRADE STEEL AFTER 475 °C EMBRITTLEMENT
2022-01-01 Rivolta, B.; Gerosa, R.; Panzeri, D.; Mariani, E.; Tavasci, F.
Metals release from stainless steel knives in simulated food contact
2022-01-01 Casaroli, A.; Boniardi, M.; Gerosa, R.; Bilo, F.; Borgese, L.; Cirelli, P.; Depero, L. E.
Alloy 625 Forgings: Thermo-Metallurgical Model of Solution-Annealing Treatment
2022-01-01 Rivolta, B.; Boniardi, M. V.; Gerosa, R.; Casaroli, A.; Panzeri, D.; Pizetta Zordao, L. H.
How to Use Metallurgical Analysis for Fire Investigation: The Case of AISI 316 Stainless Steel
2022-01-01 Casaroli, Andrea; Boniardi, MARCO VIRGINIO; Gerosa, Riccardo; Rivolta, Barbara
Manuale dell'ingegnere meccanico
2021-01-01 Gerosa, R.; Rivolta, B.
Predictive Tools for in-Line Isothermal Extrusion of 6xxx Aluminum Alloys
2021-01-01 Barella, Silvia; Gruttadauria, Andrea; Gerosa, Riccardo; Mainetti, Giacomo; Mainetti, Teodoro
Metallurgical Analysis as a Useful Method for Fire Investigation: the Case of Galvanized Steel Sheets
2021-01-01 Casaroli, A.; Boniardi, M.; Gerosa, R.; Rivolta, B.
Bending fatigue behavior of 17-4 ph gears produced by additive manufacturing
2021-01-01 Concli, F.; Bonaiti, L.; Gerosa, R.; Cortese, L.; Nalli, F.; Rosa, F.; Gorla, C.
Cyclic behavior and fatigue resistance of AISI H11 and AISI H13 tool steels
2021-01-01 Gerosa, Riccardo; Rivolta, Barbara; Gorla, Carlo; Concli, Franco
Influence of prior microstructure on the mechanical and microstructural properties of C–Mn–B steel after spheroidizing annealing
2020-01-01 Rivolta, B.; Gerosa, R.; Sala, C.; Tavasci, F.; Angelini, L.; Bolognani, N.; Panzeri, A.; Parimbelli, A.
Heat treatment and impact toughness of the f55-grade steel
2020-01-01 Rivolta, B.; Gerosa, R.; Tavasci, F.
An overview of austenitic stainless-steel rock anchors damage in an environment rich with chlorides
2019-01-01 Gruttadauria, A.; Barella, S.; Gerosa, R.
Quench Sensitivity of Aluminum Alloys
2018-01-01 Rivolta, B.; Gerosa, R.
Experimental measurement of residual stresses in Cr-Mo-V steel restrained welds with high thickness
2018-01-01 Maestri, N.; Marangoni, P.; Pettene, D.; Rivolta, B.; Gerosa, R.
The dilatometric technique for studying sigma phase precipitation kinetics in F55 steel grade
2018-01-01 Rivolta, B.; Gerosa, R.; Tavasci, F.
Effect of the heat treatment on toughness of F55 steel grade
2017-01-01 Rivolta, Barbara; Gerosa, Riccardo; Tavasci, Francesca
Metallurgical Analysis of Inconel 625 Metallic Gaskets Produced by Centrifugal Casting
2017-01-01 Rivolta, Barbara; Gerosa, Riccardo; Tavasci, Francesca; Ori Belometti, L.
Physical vapour deposition of diamond-like carbon coatings on a 7075-T6 substrate for corrosion protection at long and short fatigue lives
2017-01-01 Baragetti, Sergio; Gerosa, Riccardo; Villa, F.
High-temperature mechanical properties of P91 weld metal
2017-01-01 Rivolta, Barbara; Tavasci, Francesca; Gerosa, Riccardo; Yenus, J.
Mechanical and Microstructural Characterization of Forged Inconel 625 Ring Gaskets for Oil and Gas Application
2017-01-01 Rivolta, Barbara; Gerosa, Riccardo; Tavasci, Francesca; Ori Belometti, L.
SURFACE MODIFICATIONS OF PM STEELS: STUDY OF THE WEAR BEHAVIOR BY PIN ON DISK TESTS
2016-01-01 Rivolta, Barbara; Gerosa, Riccardo; Tavasci, Francesca
PVD DLC COATINGS FOR CORROSION PROTECTION ON A 7075-T6 SUBSTRATE AT LONG AND SHORT FATIGUE LIVES
2016-01-01 Baragetti, Sergio; Gerosa, Riccardo; Villa, F.
CARATTERIZZAZIONE DI ACCIAI INOSSIDABILI BIFASICI GRADO F55 CON TENORI DI NICHEL DIVERSI
2016-01-01 Rivolta, Barbara; Gerosa, Riccardo; Tavasci, Francesca
Effects of PVD DLC coating on 7075-T6 fatigue strength at high and low number of cycles
2016-01-01 Baragetti, Sergio; Gerosa, Riccardo; Villa, Francesco
Light alloys structural behaviour in severe environmental conditions
2016-01-01 Baragetti, Sergio; Gerosa, Riccardo; Villa, Francesco
Fatigue behaviour of DLC coated Al 7075-T6 alloy in an aggressive mixture
2015-01-01 Baragetti, Sergio; Gerosa, Riccardo; Villa, Francesco
Quasi-static behavior of notched Ti-6Al-4V specimens in water-methanol solution
2015-01-01 Sergio, Baragetti; Gerosa, Riccardo; Francesco, Villa
Development of W–SiO2 and Nb–TiO2 solar absorber coatings for combined heat and power systems at intermediate operation temperatures
2015-01-01 Ewa, Wäckelgård; Andreas, Mattsson; Ruben, Bartali; Gerosa, Riccardo; Gloria, Gottardi; Fredrik, Gustavsson; Nadhira, Laidani; Victor, Micheli; Daniel, Primetzhofer; Rivolta, Barbara
Notch Effect and Fatigue Performance of Ti-6Al-4 V Sheets in Saline Environment
2014-01-01 Baragetti, Sergio; Gerosa, Riccardo
New cermet coatings for mid-temperature applications for solar concentrated combine heat and power system
2014-01-01 Ewa, Wäckelgård; Ruben, Bartali; Gerosa, Riccardo; Nadhira, Laidani; Andreas, Mattsson; Victor, Micheli; Rivolta, Barbara
Fatigue behaviour of thin coated Al 7075 alloy with low temperature PVD coatings
2014-01-01 Sergio, Baragetti; Gerosa, Riccardo; Francesco, Villa
Steels for Plastic Molding: Relationship between Mechanical and Microstructural Properties
2014-01-01 Ghidini, A.; Rivolta, Barbara; Silva, Giuseppe; Gerosa, Riccardo
CORROSION BEHAVIOR OF A WC/C COATED 7075-T6 ALUMINUM ALLOY
2014-01-01 S., Baragetti; M., Daurù; Gerosa, Riccardo; Rivolta, Barbara
WC/C coating protection effects on 7075- T6 fatigue strength in an aggressive environment
2014-01-01 Baragetti, Sergio; Gerosa, Riccardo; Villa, Francesco
The heat treatment of austenitic stainless steel wire with different work hardening degree
2013-01-01 Gerosa, Riccardo; Rivolta, Barbara; G., Poli; M., Valsecchi
Legenda icone
- file ad accesso aperto
- file disponibili sulla rete interna
- file disponibili agli utenti autorizzati
- file disponibili solo agli amministratori
- file sotto embargo
- nessun file disponibile